root@freenas:~ # smartctl -a /dev/da2 smartctl 7.0 2018-12-30 r4883 [FreeBSD 11.3-RELEASE-p14 amd64] (local build) Copyright (C) 2002-18, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate Barracuda 7200.14 (AF) Device Model: ST3000DM002-1BJ166 Serial Number: Z504WK90 LU WWN Device Id: 5 000c50 0a36fb654 Firmware Version: CS41 User Capacity: 3,000,592,982,016 bytes [3.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-2, ACS-3 T13/2161-D revision 3b SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Tue Nov 12 20:22:35 2024 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART Status command failed: Input/output error SMART overall-health self-assessment test result: PASSED Warning: This result is based on an Attribute check. General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 89) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 317) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x1085) SCT Status supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 119 080 006 Pre-fail Always - 224742328 3 Spin_Up_Time 0x0003 092 092 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 81 5 Reallocated_Sector_Ct 0x0033 100 100 010 Pre-fail Always - 0 7 Seek_Error_Rate 0x000f 087 060 030 Pre-fail Always - 525252093 9 Power_On_Hours 0x0032 028 028 000 Old_age Always - 63766 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 81 183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 355 188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0 0 0 189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0 190 Airflow_Temperature_Cel 0x0022 076 059 045 Old_age Always - 24 (Min/Max 23/24) 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 0 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 60 193 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 590 194 Temperature_Celsius 0x0022 024 041 000 Old_age Always - 24 (0 15 0 0 0) 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 24 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 24 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 63764h+53m+40.989s 241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 23622463204 242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 135412447706 SMART Error Log Version: 1 ATA Error Count: 355 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 355 occurred at disk power-on lifetime: 55024 hours (2292 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 58 ff ff ff 4f 00 30d+05:29:55.159 READ FPDMA QUEUED 47 00 01 10 00 00 40 00 30d+05:29:55.130 READ LOG DMA EXT 60 00 58 ff ff ff 4f 00 30d+05:29:51.471 READ FPDMA QUEUED 47 00 01 10 00 00 40 00 30d+05:29:51.412 READ LOG DMA EXT 60 00 58 ff ff ff 4f 00 30d+05:29:47.758 READ FPDMA QUEUED Error 354 occurred at disk power-on lifetime: 55024 hours (2292 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 58 ff ff ff 4f 00 30d+05:29:51.471 READ FPDMA QUEUED 47 00 01 10 00 00 40 00 30d+05:29:51.412 READ LOG DMA EXT 60 00 58 ff ff ff 4f 00 30d+05:29:47.758 READ FPDMA QUEUED 47 00 01 10 00 00 40 00 30d+05:29:47.728 READ LOG DMA EXT 60 00 58 ff ff ff 4f 00 30d+05:29:44.058 READ FPDMA QUEUED Error 353 occurred at disk power-on lifetime: 55024 hours (2292 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 58 ff ff ff 4f 00 30d+05:29:47.758 READ FPDMA QUEUED 47 00 01 10 00 00 40 00 30d+05:29:47.728 READ LOG DMA EXT 60 00 58 ff ff ff 4f 00 30d+05:29:44.058 READ FPDMA QUEUED 47 00 01 10 00 00 40 00 30d+05:29:43.936 READ LOG DMA EXT 60 00 58 ff ff ff 4f 00 30d+05:29:40.276 READ FPDMA QUEUED Error 352 occurred at disk power-on lifetime: 55024 hours (2292 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 58 ff ff ff 4f 00 30d+05:29:44.058 READ FPDMA QUEUED 47 00 01 10 00 00 40 00 30d+05:29:43.936 READ LOG DMA EXT 60 00 58 ff ff ff 4f 00 30d+05:29:40.276 READ FPDMA QUEUED 61 00 10 ff ff ff 4f 00 30d+05:29:40.276 WRITE FPDMA QUEUED 61 00 10 ff ff ff 4f 00 30d+05:29:40.276 WRITE FPDMA QUEUED Error 351 occurred at disk power-on lifetime: 55024 hours (2292 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 58 ff ff ff 4f 00 30d+05:29:40.276 READ FPDMA QUEUED 61 00 10 ff ff ff 4f 00 30d+05:29:40.276 WRITE FPDMA QUEUED 61 00 10 ff ff ff 4f 00 30d+05:29:40.276 WRITE FPDMA QUEUED 61 00 10 ff ff ff 4f 00 30d+05:29:40.275 WRITE FPDMA QUEUED 61 00 20 ff ff ff 4f 00 30d+05:29:40.275 WRITE FPDMA QUEUED SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.