NIC and HBA Temperature

[Fastline]

Hello Guys,

Is there any option to check NIC and HBA temperatures? The NIC is from Intel (X550-AT2) and the HBA is LSI 3008. If not from the GUI, then from shell or something could definitely work.

Any ideas are super welcomed!

Thanks

[Fastline]

Anyone?

[SmallBarky]

This may help for the HBA. I don’t think anyone is tracking it and just follows the 200 Linear feet per minute air flow rule.

First timer with HBA cards - I am unable to check my HBA temps

Hey, Recently, I installed my first HBA (LSI 9300-8i 12Gbps SAS P16) pre-flashed in IT mode card in my TrueNAS Scale server. The card’s been working fine with passing through disks, but I am unable to check the temperature on it. I was told that it should have an onboard temp sensor, but so far I’ve had no success in gathering data from it. I’ve tried to: get the storcli info from everything: root@truenas[~]# storcli show all CLI Version = 007.2807.0000.0000 Dec 22, 2023 Operating system =…

[LarsR]

Not every NIC and HBA have temp sensors, so you’d first have to find out if your hardware has temp sensors. If they don’t its almost impossible to measure temps…

[Redcoat]

@LarsR

almost impossible

almost?

[LarsR]

I remember in the old days one of my first gaming pcs had a fan control for a 3.5" drive bay with temp sensors you could glue to components… if you can still buy those you can techically try and get temp readings from them xD

[Redcoat]

Which would be adding temp sensors to your hardware!

[LarsR]

Or he could do what i did, just slap a small noctua fan on it let it run at 50-60% at all time and don’t worry about it

[Fastline]

Yeah, did that and now the temps are 45-48c at full load.

[Fastline]

I used ethtool -m enp7s0f0 for my X550-T but this returns to an error:
netlink error: Input/output error