Create bonding failed

Hello everyone,

I’m trying to create a bond interface on my system but it failed, below my network configuration :
-I’ve an network interface connected to my Internet box whose IP address is provide by a DHCP server
-I’ve two additional interfaces (enp0s3 and enp0s5) connected to an Aruba switch, on this switch I created a tagged VLAN and I created a LACP trunk too.
Below informations logged in the syslog :

Nov 2 21:49:38 truenas dhclient[7292]: send_packet: Network is down
Nov 2 21:49:38 truenas dhclient[7292]: dhclient.c:2600: Failed to send 300 byte long packet over enp5s0 interface.
Nov 2 21:49:42 truenas kernel: 8021q: adding VLAN 0 to HW filter on device bond0
Nov 2 21:49:42 truenas kernel: 8021q: adding VLAN 0 to HW filter on device bond0
Nov 2 21:49:42 truenas kernel: bond0: (slave enp3s0): Enslaving as a backup interface with a down link
Nov 2 21:49:42 truenas kernel: bond0: (slave enp5s0): Enslaving as a backup interface with a down link
Nov 2 21:49:42 truenas avahi-daemon[3585]: Withdrawing address record for 192.168.1.15 on enp2s0.
Nov 2 21:49:42 truenas avahi-daemon[3585]: Leaving mDNS multicast group on interface enp2s0.IPv4 with address 192.168.1.15.
Nov 2 21:49:42 truenas avahi-daemon[3585]: Interface enp2s0.IPv4 no longer relevant for mDNS.
Nov 2 21:49:42 truenas avahi-daemon[3585]: Withdrawing address record for fe80::aab8:e0ff:fe06:235d on enp2s0.
Nov 2 21:49:42 truenas nscd[20969]: 20969 monitored file /etc/resolv.conf was written to
Nov 2 21:49:45 truenas kernel: igc 0000:05:00.0 enp5s0: NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX
Nov 2 21:49:45 truenas kernel: bond0: (slave enp5s0): link status definitely up, 1000 Mbps full duplex
Nov 2 21:49:45 truenas kernel: bond0: Warning: No 802.3ad response from the link partner for any adapters in the bond
Nov 2 21:49:45 truenas kernel: bond0: active interface up!
Nov 2 21:49:45 truenas kernel: igc 0000:03:00.0 enp3s0: NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX
Nov 2 21:49:45 truenas kernel: bond0: (slave enp3s0): link status definitely up, 1000 Mbps full duplex
Nov 2 21:50:13 truenas systemd[1]: Starting sysstat-collect.service - system activity accounting tool…
Nov 2 21:50:13 truenas systemd[1]: sysstat-collect.service: Deactivated successfully.
Nov 2 21:50:13 truenas systemd[1]: Finished sysstat-collect.service - system activity accounting tool.
Nov 2 21:50:42 truenas kernel: bond0: (slave enp3s0): link status definitely down, disabling slave
Nov 2 21:50:43 truenas dhclient[21210]: DHCPDISCOVER on enp3s0 to 255.255.255.255 port 67 interval 4
Nov 2 21:50:43 truenas dhclient[21209]: DHCPREQUEST for 192.168.1.15 on enp2s0 to 255.255.255.255 port 67
Nov 2 21:50:43 truenas kernel: bond0: (slave enp3s0): link status definitely down, disabling slave
Nov 2 21:50:43 truenas kernel: bond0: (slave enp5s0): link status definitely down, disabling slave
Nov 2 21:50:43 truenas kernel: bond0: now running without any active interface!
Nov 2 21:50:43 truenas kernel: bond0 (unregistering): (slave enp3s0): Releasing backup interface
Nov 2 21:50:43 truenas dhclient[21242]: DHCPDISCOVER on enp5s0 to 255.255.255.255 port 67 interval 7
Nov 2 21:50:43 truenas dhclient[21238]: DHCPDISCOVER on enp4s0 to 255.255.255.255 port 67 interval 5
Nov 2 21:50:43 truenas dhclient[21210]: receive_packet failed on enp3s0: Network is down
Nov 2 21:50:43 truenas kernel: bond0 (unregistering): (slave enp5s0): Releasing backup interface
Nov 2 21:50:43 truenas dhclient[21242]: receive_packet failed on enp5s0: Network is down
Nov 2 21:50:43 truenas kernel: bond0 (unregistering): Released all slaves
Nov 2 21:50:43 truenas nscd[20969]: 20969 monitored file /etc/resolv.conf was written to
Nov 2 21:50:45 truenas kernel: igc 0000:02:00.0 enp2s0: NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX
Nov 2 21:50:46 truenas dhclient[21210]: DHCPDISCOVER on enp3s0 to 255.255.255.255 port 67 interval 5
Nov 2 21:50:46 truenas dhclient[21210]: send_packet: Network is down
Nov 2 21:50:46 truenas dhclient[21210]: dhclient.c:2600: Failed to send 300 byte long packet over enp3s0 interface.

Thank you in advance for your help.

smokyrun