Repeated errors on different drives

TrueNAS General
1

I am getting confusing errors.

On 5/26, on device sde I receive the error “368 Offline uncorrectable sectors.” On the same date and the same time, on device sde, I receive the errork “368 Currently unreadable (pending) sectors.”

On 4/28, I received the same two errors, but this time on device sdc.

Then on 1/9, I receive the same two errors but this time on device sdd.

Then on 1/7, I receive the same two errors on device da2.

What is going on here?

Thank you for your help.

2

First of all, have you discovered time travel?

What is your hardware and system information? There’s nothing to troubleshoot without at least providing minimal info.

3

I’m sorry. 1st post.

TrueNas Scale 24.10. AMD Ryzen 5 3600. 32 Gb ECC memory. 1 x RAIDZ2 | 7 wide, pool of 7 4TB drives.

4

How are the drives connected? HBA or directly into the motherboard’s SATA ports?

Can you post the output of:

zpool status -v <poolname>

Are there are SMART errors on any drives?

5

  1. They are SATA drives connected by breakout cables to an HBA.

Milton shell
Milton shell3072×1296 228 KB

  1. No reported SMART errors.
6

Have you rebooted the system at all in between these dates? It is fairly common that the sda/b/c/etc get re-mapped to different physical drives. You’d want to confirm the SN# of the drive at the time of the error.

I’d go through the smart outputs very carefully & I’d bet you’d find a single drive with the 368 dead sectors… This only applies if you run regular SMART tests (long) - if not, then run those first.

Good news is that so far no data lost & pool looks healthy. Bad news is that one of those drives is reporting 368 dead sectors that it has remapped to healthy ones & you should consider getting a replacement once you figure out which SN# it is.