Okay, here we go…
I’m loosing my AT&T fiber connection shortly and having to switch over to a Starlink connection using CGNAT. I am trying to figure out how to setup access to my Plex server using the highly recomended Tailscale app but for the life off me I just can’t seem to figure it out. I’ve been googling and reading up on this and for some reason it’s just not clicking.
I have the Tailscale app installed on my test system. I have it connected to the Tailscale infrastructure but that’s as far as I can get. How do I get further to where the Plex container will use the Tailscale container for routing of traffic outbound so that I can get around this CGNAT BS? Does anyone here have a good write up on setting this up that they can point me to?
Also, if at all possible I’d like to not have to have my end users log into Tailscale for access. Some write ups I’ve read hint at this but I’ve not seen it outlined how to make it work.