TrueNAS scale, stops sending HDMI signal after boot

TrueNAS General
1

Hello

I am trying to run TrueNas Scale on an old Dell Optiplex 3010. I have upgraded it since I bought it, replaced the I5 CPU with an I7, put in 16 gigs of DDR3 ram. It install fine off the USB drive, when i go to boot it, it will start initializing and after it gets to something that says “Kill Switch” on the terminal my screen will go black and report no signal from the HDMI connection.

2

Are you able to connect to the web GUI for admin?

Does this Dell model have a serial number so you can look up the specs and post them?

The Dell website shows it tops out at 8GB and may contain a [GeForce GTX 1650 Low Profile] video card. That won’t work by default with 25.10.